Pitched-roof PV · Türkiye · 2020

1.55 MWp Sandwich-Panel Roof PV in Kayseri on ISOTRAP S60 Mounts

Finished module rows next to profiles in place
In brief

In 2020 ISOTEC supplied the ISOTRAP S60 mounting system for a 1.55 MWp rooftop solar plant in the organised industrial zone of Melikgazi, Kayseri. The 4,779 modules of 325 Wp sit on short aluminium S60 profiles in two lengths (290 and 540 mm) on a sandwich-panel roof.

The project

Two S60 profile lengths on an industrial roof

The plant was built on the sandwich-panel roof of an industrial facility in Kayseri. According to the structural report the roof has a double pitch of 9°; the building is 9.20 m high at an altitude of 1,047 m, and the roof sheet is 0.50 mm S235. The photos show broad roof surfaces, roof lights and profiles lined up along the ribs.

The ISOTRAP S60 system was used in two lengths on this roof: two separate structural reports were prepared, one for the S60/290 profile with a 200 mm rib spacing and one for the S60/540 profile with 500 mm. The short aluminium profiles sit across the ribs and bridge neighbouring rib crests; the modules rest on them with EasyClamp clamps.

The profiles are fixed with sealed self-drilling 5.5 × 25 screws over an EPDM rubber gasket, so the sheet stays watertight where it is pierced. The calculations assume snow zone 3 with a ground snow load of 1.49 kN/m² and a wind pressure of 0.80 kN/m² (qp,50); the modules measure 1649 × 992 × 35 mm.

Section · schematic
Modulemid clampend clampISOTRAP S profile (20–85 mm)2 screws per crest + EPDM
Schematic drawing of the general ISOTRAP S60 build-up. No dimensions from this project are shown.
Technical details
Modules
4,779 × 325 Wp
Module size
1649 × 992 × 35 mm
Roof type
Sandwich · double pitch · 9°
Profile
S60/290 · S60/540
Profile height
60 mm
Fixing
Sealed screw 5.5 × 25
Building height
9.20 m
Ground snow load
1.49 kN/m²
Wind pressure
qp,50 = 0.80 kN/m²
FAQ

Which mounting system was used on this roof in Kayseri?

ISOTEC's short-profile system for sandwich and trapezoidal roofs, ISOTRAP S60. The plant's capacity is 1.55 MWp.

Why are there two profile lengths?

The structural calculation was done separately for two profiles: 200 mm rib spacing for the S60/290 and 500 mm for the S60/540.

How were the profiles fixed to the roof?

The profiles sit across the ribs and are fixed with sealed self-drilling 5.5 × 25 screws, with an EPDM rubber gasket underneath.

Which loads does the structural calculation assume?

Snow zone 3 with a ground snow load of 1.49 kN/m² and a wind pressure of 0.80 kN/m²; the roof pitch is 9°.

From the same country

More ISOTRAP S projects in Türkiye

Planning a project on a sandwich or trapezoidal roof?

Send us the roof covering, the rib spacing and the module size, and we will prepare an ISOTRAP quotation for your project.

Erkan Öztürk

Erkan Öztürk

Founder & CEO @ ISOTEC
Solar Mounting Systems