Flat roof PV · Georgia

17 kWp Flat Roof PV in Georgia on the ISOFLAT D13 Mounting System

Module rows and roof vents on the flat roof
In brief

A 17 kWp flat roof solar system in Georgia uses ISOTEC's ISOFLAT D13 mounting system. The modules are arranged east-west in back-to-back rows and held down by ballast, without drilling into the roof membrane.

The project

East-west back-to-back rows on a flat roof

The system was installed on the flat roof of a building surrounded by hills in Georgia. The roof has vent stacks and a parapet along its edge, and the module rows were placed in the open areas between them.

ISOFLAT D13 was chosen as the mounting system: two module rows stand back to back on one symmetrical structure, facing east and west. Rails were laid out across the roof and the rows fitted onto them; triangular side plates close off the ends of the structure.

Section · schematic
13°13°EASTWESTBS3 double rear legballastTFX-2400 rail · no drilling
Schematic drawing; there is no dimension source for this project. It shows the east-west back-to-back principle of ISOFLAT D13.
Technical details
Capacity
17 kWp
Roof type
Flat roof
Tilt
13° east-west
Structure
Symmetric, paired
Fixing
Ballast, no drilling
Main rail
TFX-2400
FAQ

Which mounting system was used on this roof?

ISOTEC's east-west flat roof system ISOFLAT D13.

Was the roof membrane drilled?

No. ISOFLAT D13 is held down by ballast and does not penetrate the roof.

What is the system's capacity?

The capacity is 17 kWp.

From the same country

More flat roof and Georgia references

Planning solar on your flat roof?

Send us the roof height, the ballast load capacity and the module size, and we will prepare an ISOFLAT quotation for your project.

Erkan Öztürk

Erkan Öztürk

Founder & CEO @ ISOTEC
Solar Mounting Systems